Replacing The Battery - Honda Civic Hybrid Manual

07/08/22 17:50:40 32SND620_272
BATTERY NEGATIVE
BRACKET TERMINAL
POSITIVE TERMINAL COVER
When you remove and replace the
battery, always follow the
maintenance instructions in
Maintenance Safety on page
the warnings in this section to
prevent potential hazards.
1. Make sure the ignition switch is in
the LOCK (0) position.
2. Open the bonnet.
BATTERY
STAY
NUT
POSITIVE TERMINAL
Loosen the bolt on the negative
3.
battery cable, then disconnect the
cable from the negative ( )
220 and terminal.
Always disconnect the negative
( ) cable first, and reconnect it
−
last.

Replacing the Battery

4. Open the positive battery terminal
cover. Loosen the bolt on the
positive battery cable, then
disconnect the cable from the
positive ( ) terminal. ＋
5. Loosen the nut on each side of the
battery bracket with a wrench.
6. Pull the bottom end of each
battery stay out of the hole on the
battery base, and remove the
combination of the battery bracket
and the stays.
7. Remove the battery cover.
−
8. Take out the battery carefully.
CONTINUED
267
Maintenance