Connection and commissioning
5.2 Mounting and connection
2. Install the accessories as described in the Operating Instructions (see Chapter Product-
specific information (Page 7)).
3. Wire the accessories to the terminals for auxiliary supply connection as required.
All commands and signals for interaction with the circuit breaker pass through the
auxiliary conductor terminal system and the auxiliary conductor terminals it contains or
the CB Bus Module that is plugged in. The internal wiring to the corresponding pins is
available on every circuit breaker. By studying the labeling shown below, the user will find
the relevant pin assignment for the external wiring of the user's accessories to the
corresponding auxiliary conductor terminals. These are implemented with a screwless
push-in method and are pre-installed in the factory when internal accessories are
configured.
142
Air circuit breaker 3WL10
Manual, 11/2017, L1V30499596002-01