Avaya 400 Installation And Commissioning Manual page 23

Prerequisites:
• To confirm which route is configured as SIP, print (PRT) your route data block (RDB) in
LD 21.
• Log on to the CS 1000 Element Manager.
Procedure
1. In the Element Manager navigation pane, select System > IP Network > Nodes:
2. On the IP Telephony Node page, click the Node ID of the node to configure.
3. Click on the Gateway (SIPGw) link.
4. At the top of the page, select the Enable Gateway service on this node check
5. In the General pane, in the Vtrk Gateway Application: drop-down list, select SIP
6. In the SIP Domain Name field, enter the customer domain or HMS400R3.
7. In the Local SIP Port field, type 5060.
8. In the Gateway endpoint name: field, enter HMS400R3.
9. Under SIP Gateway Settings, from the drop-down list, select Security Disabled
10. In the Primary TLAN IP Address field, type the HMS 400 TLAN IP address.
11. In the Port box, type 5060.
12. From the Transport protocol drop-down list, select a transport protocol.
13. In the Options section, ensure the Supports Registration check box is cleared.
14. Scroll down to the SIP URI Map: section.
15. In the Private Domain Names section, in the UDP: field, type the L1 domain.
16. In the CDP: field, type the L0 and L1 domains in the format: <L0
17. Click Save.
18. Click Save again.
19. Click Transfer Now.
20. Select the HMS 400 Node Signaling Server and click Start Sync.
21. Click OK to accept the confirmation prompt.
Avaya Hospitality Messaging Server 400 Installation and Commissioning
Servers, Media Cards.
The IP Telephony Node page appears.
The Node Details page for the selected node appears
The Virtual Trunk Gateway Configuration Details page appears.
box.
Gateway (SIPGw).
in TLS Security.
domain.L1domain>.
Configuring the SIP gateway
March 2012 23