Table of Contents
Advertisement
Cetus
Personal safety equipment preparation:
•
Safety goggles
In case of leakage of lead-acid battery fluid
during maintenance, they can prevent eyes
damage.
•
Steel head safety shoes
They can prevent foot injuries when carrying
or assembling the scooter.
•
Working gloves
When relocating or disassembling iron parts,
the friction can be increased to effectively hold
the objects. In case of dealing with the
leakage of lead-acid battery fluid,
acid-resistant gloves are needed.
•
Repair tools
Please prepare the tools according to the
reference tools in the notes of each
maintenance item.
Maintenance instruction:
In order to keep your electric vehicle in optimal use,
please carry out regular maintenance.
Clean and check the following:
•
Whether the front/rear tire pressure is within the
normal range of 35-40 psi.
•
Whether the front/rear tire pattern is lower than
the normal value by more than 0.5 mm.
•
Whether the frame and components are
cleaned.
•
Whether the joints and lock points are correct
and whether there is corrosion.
•
Whether the rearview mirror and rear retro
reflector are in good condition.
•
Motor, battery, controller and other
components are free of maintenance. Please
do not disassemble them without authorization.
In case of any problems, please send them for
repair immediately.
•
It is strictly forbidden to rinse with high pressure
water so as to prevent electronic components
and wiring from becoming wet and causing
accidents.
S81201-92800~A
•
It is strictly forbidden to clean with corrosive
solvents or detergents to avoid discoloration
and deformation of plastic parts and painted
surfaces.
•
When cleaning the shell, please wipe it with a
neutral solution.
•
When cleaning the metal part of the vehicle
shroud, please wipe it with a dry cloth.
•
For the internal electrical appliances and wiring
of the vehicle shroud, please try to avoid the
contact of the detergents and the water. If it is
needed to wipe the surface, it is recommended
to use a dry cloth.
It is recommended that the following parts be oiled
and lubricated for every 3,000 km or every
six months of use.
Front/rear axle
Seat holder fixing hole
Upper and lower copper
beads set of center bar
Caution:
Oiling is prohibited on the following parts:
shroud, tires, brake drums, electromagnetic
brakes, and brake rubber block.
Service Manual
6
Advertisement
Table of Contents
