Table of Contents
Advertisement
Cetus
6-3
Seat support maintenance:
Hex wrench 17 x 2pcs
Cross screwdriver x 1pcs
1.
Refer to 2-1 Battery power-off: The scooter is
powered off.
2.
Remove the upper set of fixing screw (M8
x35L x 1pcs).
3.
Remove the upper set of fixing screws (M10
x20L x 4pcs).
4.
The entire set of seat holder can be removed.
Please refer back in reverse for reassembly and
replacement.
6-4
Main controller maintenance:
Allen wrench 4 x 1pcs
1.
Refer to 2-1 Battery power-off: The scooter is
powered off.
2.
Remove the main control wire screws (M5 x
12L x 4pcs) and the connector.
3.
Main controller wiring instructions:
(1). Scooter main cable
(2). Motor brake cable
(3). Battery "+" "-" pole connector
(4). Motor "+" "-" pole connector
S81201-92800~A
4.
Remove the main controller fixing screws (ø4
x 25L x 2pcs).
5.
The entire set of controllers can be removed.
Please refer back in reverse for reassembly and
replacement.
Caution:
If the function of the electrical equipment of the
scooter is abnormal or invalid, the reason may
be the controller connector is falling off. First
check whether the controller connector is falling
off. If it is normal, the controller may be
damaged. Please replace with a new one.
Connector 3, 4 motor / battery "+" / "-" pole
connector, please do not connect the wrong
position. Please note that if the connection is
wrong, the controller may be burnt out.
After reassembling or replacing the controller,
please confirm to connect the connector and the
connector screw, so as to avoid falling off,
causing the abnormality of the scooter.
Service Manual
27
Advertisement
Table of Contents
