Panel Wiring Instruction; Maintenance Of The Vr Initiator Controller - Invacare Cetus Service Manual

Cetus
Caution:
If there is a problem with the control panel,
please reconnect the main cable connector first.
If there is no effect, please replace with a new
one directly.
3-4

Panel wiring instruction:

Cross screwdriver x 1pcs
1. Refer to 2-1 Battery power-off: The scooter is
powered off.
2. Refer to 3-3 Control panel maintenance:
Open the upper control panel.
3. Check the corresponding connector.
A. Main control cable connector
B. Buzzer switch connector
C. VR initiator controller connector
D. Cyclometer transmission wiring connector
S81201-92800~A
Caution:
The shape and color of different panel
connectors are different, which avoids the
wrong connection of the connector, but please
do not modify the connector or circuit, which
may cause serious problems.
For faults related to electrical products of the
scooters, it is recommended to check the above
connectors first to confirm whether they fall off
and cause an abnormality.
3-5 Maintenance of the VR initiator
controller:
Cross screwdriver x 1pcs
1. Refer to 2-1 Battery power-off: The scooter is
powered off.
2. Remove the head actuating lever clamping
screws (M4 x12Lx2pcs).
3. Please refer to 3-3 upper control panel
maintenance to open the control panel.
4. Remove the VR initiator controller after the
fixing screws on the inside of the head
steering lever are removed (M4 x12Lx2pcs).
Service Manual
14