Table of Contents
Advertisement
Cetus
7
WHEELS AND REAR
SECTION OF
ELECTRONICS/LIGHTS
7-1
Front wheel maintenance:
Socket wrench 17 x 1pcs
Allen wrench 8 x 1pcs
1.
Refer to 2-1 Battery power-off: The scooter is
powered off.
2.
Please keep the front wheel of the scooter
suspending in midair.
3.
Remove the nut cover of the rim outside.
4.
Remove the lock nut (M10) and the spacer.
5.
Pull out the front wheel.
6.
By this step the tire can be replaced.
7.
Remove the bearings (2 pcs) and socket (1
pcs).
8.
Loosen the rim lock screw (M10 xP1.5 x 35L).
9.
The rim can be separated from the tire.
The left/right front wheels can be disassembled in
the same way.
Please refer back in reverse for reassembly and
replacement.
S81201-92800~A
Caution:
Standard front tire specifications:
•
Tire pressure: 35-40 psi
•
Tread pattern standard: more than
0.5 mm
The front wheel left/right disassembly method is
the same.
If the tire has abnormalities such as
yellowing/deformation/damage/air leakage
/shallow tread pattern, please replace with a
new one.
Scooter tires are consumables. It is
recommended to check daily before running, in
order to ensure safety.
Avoid placing the scooter tires near fire source,
water source and heat source to prevent the tire
from reducing its serving life.
Avoid scooter tires contacting with chemicals, oil
to prevent tire deterioration.
7-2
Speedometer drive maintenance
(right front wheel):
No tools
1.
Refer to 2-1 Battery power-off: The scooter is
powered off.
2.
Refer to 7-1 Front wheel maintenance:
Remove the right front wheel.
3.
Loosen the speedometer cable.
4.
Take out the speedometer drive.
Service Manual
28
Advertisement
Table of Contents
