Invacare Cetus Service Manual page 25

Cetus
8. Remove the entire set of bead-bowls.
9. Remove the lower center bar and the steel
bead set.
Please refer back in reverse for reassembly and
replacement.
S81201-92800~A
Caution:
Step 3. The front wheel connecting lever is
connected to the bottom of the center bar, which
must be removed. If it is not disassembled, the
center bar will not be able to be removed due to
the front wheel suspension.
Step 7. To remove the center bar bead-bowl set,
a water channel clamp must be used.
There is a set of steel beads at the bottom of the
center bar. Please pay attention to avoid falling
or missing when disassembling/reassembling.
The beads should be placed at the direction of
upwards.
If the steel bead set needs to be reassembled or
replaced, it is recommended to apply a small
amount of grease to the upper and lower steel
bead sets for lubrication.
When removing the center bar, it is needed to
lift the front end of the whole scooter. It can be
operated by two or more people, even with the
aid of a mechanical hoist.
Service Manual
25