Chapter 2
F-2-35
15) Close the front cover [1].
F-2-36
2-16
2.2.4 Securing the
Copier Main Unit
- With a pedestal installed
1) Move the copier to the location where it
will be installed, and then secure it with
the 4 adjuster wheels of the pedestal.
- Without a pedestal installed
1) Remove the cassettes 1 and 2 and
tighten the adjusting screws [1] at the
base plate temporarily until the screw
legs touch the bottom slightly.
F-2-37
2) Check if the machine wobbles while it is
lying on the desk or the floor, and
tighten
the
adjusting
necessary.
- When it wobbles in the direction shown
by the arrow A, tighten the screw at the
right side in the above picture.
0006-6767
screws
if