Reseat Paper At Manual Feed - Xerox Phaser 6128MFP Service Manual

Reseat Paper at Manual Feed

Phaser 6128MFP Service Manual
The Manual Feed No Paper Sensor did not detect media within the specified time.
The following troubleshooting procedure applies to this error.
Applicable Error
• Reseat Paper at Manual Feeed Slot
Initial Actions
• Check the media path for obstructions or debris.
• Check manual feed guide adjustment.
• Check that the media required by the print job is the type/size loaded.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Registration Roller Actuator, PL3.3.8
Registration Sensor, PL3.2.13
Manual Feed Actuator, PL3.2.14
Main Drive Assembly, PL7.1.2
Feed Drive Assembly, PL7.1.4
Left Side Harness, PL10.4.18
MCU Board, PL10.7.7
Main Motor Harness, PL10.8.7
Registration (KSNR) Harness, PL10.8.9
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the media size.
Does media size match the print
job?
2 Check the Front Cover latch.
Does the Front Cover latch correctly?
3 Run the Main Motor test (DO-0) on
(page 4-41).
Does the motor and Registration
Rollers rotate?
Error Messages and Codes
Wiring and Plug/Jack Map References
"Map 2 - Feed and Laser Unit" on page 10-7
"Media Feed" on page 10-15
"Main Drive" on page 10-16
Yes
Replace the
media.
Go to step 3.
Go to step 4.
No
Go to step 2.
Repair or
replace the
Front Cover
(page 8-15).
Repair or
replace the
Main Drive
Assembly
(page 8-58).
3-83