Error Messages and Codes
Insert Imaging Unit Error
Applicable Error
Initial Actions
3-72
An error occurred while reading the Imaging Unit CRUMs.
•
Insert Imaging Unit
•
Check that the correct Imaging Unit is installed for this model.
•
Remove and reseat the Imaging Unit.
•
Cycle system power.
•
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit PL4.1.21
MCU Board, PL10.7.7
Imaging Unit Harness, PL10.8.11
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the Imaging Unit CRUM
harness.
Disconnect P/J42 and P/J422 and
check continuity.
Is the harness damaged?
2
Replace the Imaging Unit
(page 8-8).
NOTE
Remove the 8 sealing tapes from
the new Imaging Unit before
installation.
Does the error persist?
Wiring and Plug/Jack Map References
"Map 1 - MCU Board" on page 10-6
"Xerographics" on page 10-18
Yes
No
Repair the
Go to step 2.
harness.
Replace the
Complete.
MCU Board
(page 8-57).
Phaser 6128MFP Service Manual