Xerox Phaser 6128MFP Service Manual page 298

General Troubleshooting
4-28
Test Control Panel Display
Print Settings Ready
Processing
Installation Provides printer installation information.
Serial No. HATxxxxxx
or
HARxxxxxx
Tone Tone Correction
Correction
ON *
OFF
Display
Counter
Hex Dump OFF *
ON
Pixel Counter Y: nn.n
C: nn.n
M: nn.n
K: nn.n
Configuration
Counter Type
Print Counter Numeric counts of activity.
Test Description
Prints the configured settings
through the Control Panel.
The Print Settings page contains:
Serial No.
HexDump On/Off Information
Tone Correction On/Off
Information
Color Print Count
B/W Print Count
Total Print Count
Color Backup Count
B/W Backup Count
Total Backup Count
Color Error Count
B/W Error Count
Displays the 6 digit Serial Number.
This value is read-only.
Controls TRC in conjunction with
process control to keep density
constant. Turn Off tone correction
when correction exceeds the limit
due to machine-to-machine
variation. Sets the printer Tone
Correction mode On/Off.
NOTE: Note:
When the Tone Correction
has been changed, an "*" is displayed
next to the text.
Not used in this printer.
Sets HexDump On/Off. Used to
analyze received data in case of an
error. Setting Hex Dump to On
enables printing of received data via
[Info Page] under [Print info].
Displays the ratio (% used) of the
number of pixel per C/M/Y/K counted
by the Controller to A4 size area
except 4 mm area from the edge on
the last page print.
100% = empty Toner Cartridge
The value is rounded off to one
decimal place.
For B/W print, only K is displayed.
The ranges are from 0-100% for
each color (CMYK).
Not used in this printer.
Not used in this printer.
Phaser 6128MFP Service Manual