Enabling/Disabling Automatic Color Registration; Adjusting Color Registration - Xerox Phaser 6128MFP Service Manual

Enabling/Disabling Automatic Color Registration

Adjusting Color Registration

Phaser 6128MFP Service Manual
This procedure provides instructions for how to enable or disable the Automatic
Color Registration function after a new Imaging Unit is installed.
• If the function is set to On, the printer will calibrate the color alignment every
time it detects a new Imaging Unit.
• If the function is set to Off, calibration will not occur. This allows users to save
toner.
To enable or disable the Automatic Color Registration:
1. From the Control Panel, press the System button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press the OK
button.
3. Press the Up Arrow or Down Arrow button to find Maintenance Mode. Press
the OK button.
4. Press the Up Arrow or Down Arrow button find Adjust
button.
5. Press the Up Arrow or Down Arrow button to turn automatic color
registration On or Off.
Color Registration can be automatically or manually adjusted.
Determining the Values
From the lines to the right of the Y (yellow), M (magenta), and C (cyan) pattern,
find the values of the straightest lines.
When "0" is the value nearest the straightest line, you do not need to adjust the
color registration. When the value is not "0," refer to "Manual Color Registration
Adjustment" on page 6-4.
Auto Adjustment
1. From the Control Panel, press the System button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press the OK
button.
3. Press the Up Arrow or Down Arrow button to find Maintenance Mode. Press
the OK button.
4. Press the Up Arrow or Down Arrow button find Adjust Color Regi. Press the
OK button.
5. The Auto Adjust
6. Are you sure? message is displayed. Press the OK button to start the Auto
Adjustment procedure.
7. The printer starts the auto Color Registration process.
8. When the auto Color Registration is completed, the Ready menu is displayed.
menu is displayed. Press the OK button.
Adjustments and Calibrations
Regi. Press the OK
6-3