Front Cover Open Close Front Cover - Xerox Phaser 6128MFP Service Manual

Front Cover Open Close Front Cover

Phaser 6128MFP Service Manual
Troubleshooting Procedure Table (continued)
Step Actions and Questions
3 Check P/J40 and P/J41 on the MCU
Board, and P/J411 and P/J412 on
the laser Unit.
Are the connections secure?
4 Does the error still occur when the
power is turned On?
5 Check the ROS RE and ROS Video
harnesses for continuity.
Is the harness damaged?
6 Does the error still occur when the
power is turned On?
7 Replace the Laser Unit (page 8-98).
Does the error persist?
The Interlock Switch indicates the Front Cover is open. The following
troubleshooting procedure applies to this error.
Applicable Error
• Front Cover Open Close Front Cover
Initial Actions
• Check the Front Cover interlock actuator and latch for damage.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Front Cover, PL1.1.8
Interlock Harness, PL10.6.4
LVPS, PL10.6.16
MCU Board, PL10.7.7
LVPS Main Harness, PL10.8.14
Error Messages and Codes
Yes
Go to step 5
Go to step 5.
Repair the
harness, then
go to step 6.
Go to step 7.
Replace the
MCU Board
(page 8-57).
Wiring and Plug/Jack Map References
"Map 1 - MCU Board" on page 10-6
"Map 3 - Electrical and Drive" on page 10-8
"LVPS" on page 10-14
No
Reconnect the
connections.
Go to step 4.
Complete.
Go to step 7.
Complete.
Complete.
3-105