Phaser 6128MFP Service Manual
Tray Feed Solenoid
Solenoid that controls the drive of the Tray Feed Roll
Note
Install the safety interlock override to provide power to the device under test.
Run this test when the Feed Roller fails to rotate during the Feed Solenoid (DO-
b) test.
1. Remove the Left Side Cover (page 8-17).
2. Enter Service Diagnostics (page 4-4).
3. Perform the Tray 2 Feed Solenoid (Auto) test: Engine Diag > Motor Test> Tray
Feed Solenoid (DO-2f).
4. Observe the Feed Solenoid movement.
6. Press the Stop button to stop the Feed Solenoid (Auto) test.
General Troubleshooting
s6128mfp-089
4-49