Clamp Rail; Assembling And Disassembling The Clamp Rail - DURKOPP ADLER beisler 2112-5 Service Instructions Manual

Clamp rail

3

3.1 Assembling and disassembling the clamp rail

The clamp rail must be replaced if the protective lining at the bottom side
of the rail is worn.
Fig. 1: Assembling and disassembling the clamp rail
(1) - Clamp rail
(2) - Screw
Disassembling the clamp rail
To disassemble the clamp rail:
1. Lift the main clamp (3).
2. Loosen the screw (2).
3. Pull the clamp rail (1) down and out.
Assembling the clamp rail
To assemble the clamp rail:
1. Insert the clamp rail (1) into the fixture and push it up until it reaches
2. Tighten the screw (2).
Service Instructions 2112-5 - 00.0 - 02/2020
Clamp rail
WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before adjusting the
settings of the clamp rail.
the stop.
Make sure the clamp rail (1) is positioned evenly in the fixture.
① ②
(3) - Main clamp
③
11