Table of Contents
Advertisement
Setting up the machine
6. Lower the stamp (2).
7. Check the downforce pressure and readjust it if necessary.
7.3 Adjusting the guide laser
The guide laser marks the line-up position of simple labels on the pocket
facing.
Fig. 14: Adjusting the guide laser
(1) - Angular bracket
(2) - Screw
(3) - Screw
Adjusting the height
To adjust the height of the guide laser:
1. Loosen the screw (6) on the rear of the worktable.
2. Position the holder of the laser (6) at the desired height.
3. Tighten the screw (6).
Service Instructions 2112-5 - 00.0 - 02/2020
WARNING
Risk of injury from laser beams!
Retina damage possible.
NEVER look directly into the laser beam.
NEVER allow optical equipment such as burning
glasses or lenses to interfere with the laser beam
path.
②
③
④
①
(4) - Laser
(5) - Laser
(6) - Screw
⑥
⑤
25
Advertisement
Table of Contents
