Adjusting The Cutters - DURKOPP ADLER beisler 2112-5 Service Instructions Manual

Setting up the machine

7.6 Adjusting the cutters

Fig. 19: Adjusting the cutters
(1) - Adjusting wheel
(2) - Angle arm
The cutting depth of the gusset in the left fly piece is adjusted by various
settings on the 4 cutters.
Proper setting
The 2 cutters for the gusset in the left fly piece and in the left trouser
component must be aligned to each other in a way that ensures that both
cutting positions are exactly flush.
Adjusting the cutting depth of the cutters
To adjust the cutting depth of the cutters:
1. Turn the adjusting wheel (1).
Adjusting the cutting depth of the gusset in the left fly piece
The cutting depth of the gusset in the left fly piece depends on the cutter
block's mounting position.
To adjust the cutting depth of the gusset:
1. Reposition the cutter block in the slotted holes of the mounting
2. Position the cutter at an exact distance to the stop rail (3).
Adjusting the vertical position of the cutters
To adjust the vertical position of the cutters:
1. Reposition the cutter block in the slotted holes of the angle arm (2).
Service Instructions 2112-5 - 00.0 - 02/2020
①
②
bracket (4).
Make sure that the lowered cutters are positioned flush with the upper
edge of the working plate / the pick-up plate.
③ ②
(3) - Stop rail
(4) - Mounting bracket
④
31