Table of Contents
Advertisement
Menu item
[Motion Sensor
Select the sensor connected to your TZT9F unit. For all
Type]
sensors other than SC-50 and SC-110, select [SC-30].
Note: This menu item is not available when [Fish Finder
Source] is set to [TZT9F].
[Antenna Posi-
Set the distance from the antenna unit to the transducer in
tion Bow/Stern
the bow-stern direction. If the transducer is located on the
HF (LF)]
fore side, set a positive value.
[Antenna Posi-
Set the distance from the transducer to the antenna unit in
tion Up/Down HF
the vertical direction.If the transducer is located on the bow
(LF)]
side, set a positive value.
[Antenna Port/
Set the distance from the antenna unit to the transducer in
Starboard HF
the port-starboard direction. If the transducer is located on
(LF)]
the starboard side, set a positive value.
Transducer mismount correction
If the transducer for DFF-3D is installed facing the stern, set [Transducer Mis-mount
Correction] to [ON] in the [Settings]→[Multi Beam Sonar]→[Initial Setup]→[Transduc-
er Setup] menu.
3.6
Wireless LAN Setting
3.6.1
How to join an existing wireless network
By connecting to an existing network, you may download software updates and
weather information from the internet.
1. Tap the Home icon to show the home screen and display mode settings.
2. Tap [Settings], then [General].
3. Tap [Wireless LAN Settings].
4. Tap [Wireless Mode].
5. Tap [Connect to existing LAN] to show a mark, then tap the [<] icon at the top
left of the display.
6. Turn on [Wireless] in the [ENABLE WIRELESS] menu.
7. Tap [Scan] to scan the vicinity for accessible WLAN networks. Available networks
are listed. To delete all WLAN networks, select [Forget All Available Networks].
8. Tap the appropriate WLAN network to show the following display.
3. HOW TO SET UP THE EQUIPMENT
Description
CANCEL
FORGET
CONNECT
Options
(setting range)
[SC30],
[SC50_SC110]
-99 to +99
-0.00 to +99.9
-99.9 to +99.9
3-21
Advertisement
Table of Contents
