Table of Contents
Advertisement
WHEELS AND TIRES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Wheel Installation
B
To decrease the risk of compo-
nent damage, do not tighten lug
nuts to more than 85 ft. lbs. (115
Nm) torque.
NOTICE: Always follow the cross-sequence pattern
when you install the lug nuts to make sure the wheel
is evenly seated against the hub.
With the valve stem to the outside of wheel, install the
wheel onto the hub with lug nuts.
38
Finger tighten lug nuts (1) in the cross-sequence pattern
as shown (Figure 1). Continue to tighten the lug nuts in 20
ft. lbs. (27 Nm) increments in the cross-sequence pattern
until the correct torque value shown below is reached.
Item
1
Tire Style May Vary
Figure 1 Wheels and Tires
Repair and Service Manual
Torque Specification
65 - 85
ft.lbs. (88 - 115 Nm)
Valve Stem
Cap
1
4
1
Cross Sequence
Valve stem should always
be to outside of the wheel.
Always replace the valve stem cap.
3
2
653045
Advertisement
Table of Contents
