Table of Contents
Advertisement
FRONT SUSPENSION AND STEERING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Replace the dust cap (7).
B
STEERING
Front of Vehicle
Rack Ball Joint Replacement
Tool List
Needle Nose Pliers...................................................... 1
Wrench, 11/16" ............................................................ 1
Ball Joint Separator ..................................................... 1
Plastic Faced Hammer ................................................ 1
Tape Measure.............................................................. 1
88
19
6
10
6
7
Figure 14 Steering Components
Lower the vehicle per the SAFETY section. Tighten the
front wheel(s) per the WHEELS AND TIRES section.
15
14
13
18
12
20
Axle shown for
reference only
16
17
8
Flat Section
Wrench, 3/4" ................................................................1
Torque Wrench, ft. lbs. .................................................1
Quantity
Socket, 11/16" ..............................................................1
To remove the rack ball joint (1), loosen the lug nuts on
the passenger side front wheel. Lift and support the front
of the vehicle per the SAFETY section (Figure 14).
Remove the passenger side front wheel and turn the
Repair and Service Manual
1
4
5
10
3
6
7
653045
2
Advertisement
Table of Contents
