Table of Contents
Advertisement
FAULT TESTING
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
STARTER FAULT TESTING
B
CONDITION
STARTER IS NOISY
SUSPENSION AND STEERING FAULT
TESTING
CONDITION
UNEVEN TIRE WEAR
PLAY IN STEERING
VIBRATION
STEERING PULLS TO ONE
SIDE
146
POSSIBLE CAUSE
Bolts are loose
Starter has foreign matter inside
Bearings are faulty
Bearings contain foreign matter
Fig. 3 Starter/Generator Troubleshooting
POSSIBLE CAUSE
Incorrect tire pressure
Improper alignment (Incorrect toe
in)
Steering wheel loose
Steering components worn
Loose wheel bearings
Steering components worn
Loose wheel bearings
Out of round tires, wheels, or brake
drums
Incorrect tire pressure
Dragging wheel brakes
Suspension component failure
Alignment incorrect
Fig. 4 Suspension and Steering Troubleshooting
Repair and Service Manual
CORRECTION
Tighten to correct torque
Clean starter interior
Replace
Replace
CORRECTION
Inflate to recommended pressure. See GENERAL SPECI-
FICATION.
Align front tires
Inspect splines - replace steering wheel if required; Tighten
steering wheel nut
Replace
Adjust or replace
Replace
Adjust or replace
Inspect and replace if out of round
Inflate to recommended pressure
Brake system
Repair
Align
653045
Advertisement
Table of Contents
