Field Service Ver. 1.0 Nov. 2008
12.2.10
AUTO CONTINUE
Function
• Select whether or not printing continues when a size error occurs during printing.
• If [OFF] is selected, an error occurs if the size of paper being printed on is different from
the size of paper specified in the printer driver.
Use
• If [ON] is selected, no error occurs if the size of paper being printed on is different from
the size of paper specified in the printer driver.
• The default setting is OFF.
Setting/
procedure
12.2.11
IMAGE REFRESH
• Use this function to perform aging of the toner cartridge, thereby making less noticeable
Function
the faint lines extending in parallel with the main scanning direction occurring at a pitch
of 24 mm.
NOTE
Use
• Execution of the image refresh mode consumes toner.
• This function does not help uneven density at a pitch of 25 mm.
• The default setting is OFF.
Setting/
procedure
12.2.12
DUPLEX SPEED
• To set print speed and image quality for duplex printing.
Function
• If AUTOMATIC is selected, the print speed is automatically selected.
• If SPEED is selected, the print speed has priority; however, the print quality may
Use
decrease.
• If QUALITY is selected, the print quality has priority; therefore, the print speed will
decrease while the print quality may increase.
• The default setting is AUTOMATIC.
Setting/
procedure
12.2.13
CALIBRATION
Function
• Executes the image stabilization sequence.
• To calibrate the engine when there are print image quality problems.
Use
• To calibrate the engine when the imaging cartridge and 2nd transfer roller are replaced
with new ones.
• The default setting is OFF.
Setting/
procedure
1. Select [MACHINE SETTING] and then [CALIBRATION], and press the Select key.
2. Select [ON] and press the Select key.
3. Image stabilization is executed.
"AUTOMATIC" / SPEED / QUALITY
http://www.manuals4you.com
ON / "OFF"
ON / "OFF"
ON / "OFF"
12. UTILITY mode
91