11. Utility mode
11.2.10
INITIAL MODE
Function
• To set the mode (Copy mode or Fax mode) that the machine starts up in or returns to
after the Control Panel is reset.
Use
• The default setting is COPY.
Setting/
procedure
"COPY"
11.2.11
TONER EMPTY
Function
• Specifies whether to stop or continue printing when a toner empty condition is detected.
Use
• To permit printing upon a toner empty condition.
• The default setting is STOP.
"STOP"
Setting/
• If [STOP] is selected, printing, copying and faxing stop when the toner runs out.
procedure
• If [BW CONTINUE] is selected, printing, copying and faxing do not stop when the toner
runs out.
Printing, copying, or faxing continues only if the black toner is available.
11.2.12
TONER NEAR EMPTY
Function
• To set whether to display a message when a toner near empty state is detected.
Use
• Use this setting to display a message when a toner near empty state is detected.
• The default setting is ON.
Setting/
procedure
"ON"
11.2.13
AUTO CONTINUE
• Enables or disables printing when the size of the media loaded in the tray does not
Function
match that of the print data.
• To print data on the media loaded in the tray if the media loaded in the tray does not
Use
match that of the print data.
• The default setting is OFF.
Setting/
procedure
ON
11.2.14
CALIBRATION
Function
• Executes the image stabilization sequence.
• To calibrate the engine when there are print image quality problems.
Use
• To calibrate the engine when the transfer belt unit and 2nd transfer roller are replaced
with new ones.
• The default setting is OFF.
ON
Setting/
procedure
1. Select [MACHINE SETTING] and then [CALIBRATION], and press the Select key.
2. Select [ON] and press the Select key.
3. Image stabilization is executed.
118
FAX
BW CONTINUE
OFF
"OFF"
"OFF"
Field Service Ver. 1.0 May 2008