Admin. Management; Administrator No; Remote Monitor; Network Setting - Konica Minolta magicolor 1680MF Service Manual

Field Service Ver. 1.0 Nov. 2008

12.4 ADMIN. MANAGEMENT

• The ADMIN. MANAGEMENT menu is accessible only by the administrator.
To display the settings for this menu, select [ADMIN. MANAGEMENT], use the keypad to
type in the 6-digit administrator access code, and then press the Select key.
12.4.1

ADMINISTRATOR NO.

Function
• Use to change the ADMINISTRATOR NO.
Use
• The default setting is 000000.
Setting/
1. Select [ADMINISTRATOR NO.] and press the Select key.
procedure
2. Enter the existing 6-digit administrator number and press the Select key.
3. Enter the new 6-digit administrator number and press the Select key.
12.4.2

REMOTE MONITOR

Function
• Set if the phone line connection is to be enabled for Remote Setup Utility.
Use
• The default setting is OFF.
Setting/
procedure
12.4.3

NETWORK SETTING

A. TCP/IP
Function • Enables TCP/IP
• To specify that the printer is connected to a TCP/IP network.
Use ENABLE: Print can be made at TCP/IP environment.
DISABLE: Print cannot be made at TCP/IP environment.
• The default setting is ENABLE.
Setting/
procedure
B. IP ADDR. SETTING
Function • Sets the IP address of the printer used for the network.
Use • To set the printer's IP address.
• The default setting is AUTO.
• If AUTO is selected, the IP address is automatically acquired from the DHCP server.
Setting/
NOTE
procedure
• AUTO is only enabled if there is a DHCP server available on the network.
• When AUTO is selected, there is no need to set the SUBNET MASK or GATEWAY
setting.
• If SPECIFY is selected, the screen for entering the IP address appears.
DISABLE / "ENABLE"
"AUTO" / SPECIFY
http://www.manuals4you.com
"OFF" / ON
12. UTILITY mode
93