Kubota GL6000A-AU-B Workshop Manual page 97

GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
Oil Pan and Oil Strainer
1. Remove the oil pan mounting screws (5).
2. Remove the oil pan (4) by lightly tapping the rim of the pan with
a wooden hammer.
3. Remove the oil strainer (3).
(When reassembling)
• After cleaning the oil strainer, check to see that the filter mesh
is in clean, and install it.
• Visually check the O-ring (1), apply engine oil, and install it.
• Securely fit the O-ring to the oil strainer.
• To avoid uneven tightening, tighten oil pan mounting screws (5)
in diagonal order from the center.
For GL6000A-AU-B, GL6000D-AU-B
• Using the hole (7) numbered "2", install the oil strainer by
mounting screw.
For GL9000A-AU-B, GL9000D-AU-B
• Using the hole (6) numbered "3", install the oil strainer by
mounting screw.
IMPORTANT
• Scrape off the old adhesive completely. Wipe the sealing
surface clean using waste cloth soaked with gasoline. Now
apply new adhesive 3.0 to 5.0 mm (0.12 to 0.19 in.) thick all
over the contact surface. Apply the adhesive also on the
center of the flange as well as on the inner wall of each bolt
hole.
• Cut the nozzle of the "liquid gasket" (Three Bond 1207D or
equivalent) container at its second notch. Apply "liquid
gasket" about 5.0 mm (1.09 in.) thick.
Within 20 minutes after the application of fluid sealant,
reassemble the components.
30 minutes, and pour oil in the crankcase.
(1) O-ring
(2) Screw
(3) Oil Strainer
(4) Oil Pan
1-S35
ENGINE
Wait then for
(5) Oil Pan Mounting Screw
(6) Hole (for GL9000A-AU-B,
GL9000D-AU-B)
(7) Hole (for GL6000A-AU-B,
GL6000D-AU-B)
9Y1211607ENS0052US0
KiSC issued 06, 2016 A
about