Kubota GL6000A-AU-B Workshop Manual page 96

GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
Fuel Camshaft
1. Remove the retaining plate (1).
2. Remove the fork lever holder mounting screws (8), then draw
out the fuel camshaft (2) with the governor fork assembly.
(When reassembling)
• Hook the governor spring (7) to the fork lever 2 (6) before
installing the fork lever assembly to the crankcase.
(1) Retaining Plate
(2) Fuel Camshaft
(3) Injection Pump Gear
(4) Governor Sleeve
Oil Pump and Crankshaft Gear
1. Remove the oil pump gear (5).
2. Remove the oil pump (6).
3. Remove the collar (4), O-ring (3) and crankshaft oil slinger (2).
4. Remove the crankshaft gear (1) with a puller.
(When reassembling)
• Install the collar (4) after aligning the marks on the gears. (See
page the figure at "Idle Gear".)
(1) Crankshaft Gear
(2) Crankshaft Oil Slinger
(3) O-ring
1-S34
ENGINE
(5) Fork Lever 1
(6) Fork Lever 2
(7) Governor Spring
(8) Fork Lever Holder Mounting Screw
9Y1211607ENS0050US0
(4) Crankshaft Collar
(5) Oil Pump Gear
(6) Oil Pump
9Y1211607ENS0051US0
KiSC issued 06, 2016 A