Tightening Torques; Tightening Torques For Special Use Screws, Bolts And Nuts - Kubota GL6000A-AU-B Workshop Manual

GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM

3. TIGHTENING TORQUES

Tightening torques of screws, bolts and nuts on the table below are especially specified.
(For general use screws, bolts and nuts: See page "5. TIGHTENING TORQUES" on page G-12.)
[1] TIGHTENING TORQUES FOR SPECIAL USE SCREWS, BOLTS
AND NUTS
NOTE
• In removing and applying the screws, bolts and nuts marked with " * ", pneumatic wrench or similar
pneumatic tool, if employed, must be used with enough care not to get them seized.
• For " * " marked screws, bolts and nuts on the table, apply engine oil to their threads and seats before
tightening.
[GL6000A-AU-B, GL6000D-AU-B]
Stator mounting screw
Rotor assembly mounting screw
PTO shaft mounting screw
Engine mounting nut
Generator mounting nut
[GL9000A-AU-B, GL9000D-AU-B]
Stator mounting screw
Rotor assembly mounting screw
PTO shaft mounting screw
Engine mounting nut
Generator mounting nut
Item
Item
N·m
6 to 8
35 to 44
48 to 55
20 to 27
20 to 27
N·m
19 to 21
20 to 27
20 to 27
54 to 68
54 to 68
2-S10
GENERATOR
9Y1211607GRS0010US0
kgf·m lbf·ft
0.6 to 0.9 5 to 6
3.5 to 4.5 26 to 32
4.9 to 5.7 36 to 41
2.0 to 2.8 15 to 20
2.0 to 2.8 15 to 20
kgf·m lbf·ft
1.9 to 2.2 14 to 15
2.0 to 2.8 15 to 20
2.0 to 2.8 15 to 20
5.5 to 7.0 40 to 50
5.5 to 7.0 40 to 50
9Y1211607GRS0011US0
KiSC issued 06, 2016 A