Kubota GL6000A-AU-B Workshop Manual page 40

GL6000A-AU-B, GL6000D-AU-B,GL9000A-AU-B, GL9000D-AU-B, WSM
Check of Fan Belt Tension
1. Measure the deflection (A), depressing the belt halfway
between the fan drive pulley and alternator pulley at specified
force 98 N (10 kgf, 22 lbf).
2. If the measurement is not within the factory specifications,
loosen the alternator mounting screws and relocate the
alternator to adjust.
Deflection (A) Factory specification
(A) Deflection
Fan Belt Damage and Wear
1. Check the fan belt for damage.
2. If the fan belt is damaged, replace it.
3. Check if the fan belt is worn and sunk in the pulley groove.
4. If the fan belt is nearly worn out and deeply sunk in the pulley
groove, replace it.
(A) Good
Cleaning of Fuel Filter Element
1. Close the fuel valve (1).
2. Remove the fuel filter element (2).
3. After cleaning the fuel filter element (2), screwing it in by hand.
NOTE
• Check for fuel leak after checking it.
(1) Fuel Valve
G-19
GENERAL
7.0 to 9.0 mm
0.28 to 0.35 in.
9Y1211607GEG0028US0
(B) Bad
9Y1211607GEG0029US0
(2) Fuel Filter Element
9Y1211607GEG0030US0
KiSC issued 06, 2016 A