Confirming Connected Stations; Confirming All Recognized Addresses - Panasonic S-Link FP2 Manual

Operation
5.4 S−LINK I/O Device Address Recognition
5.4.5

Confirming Connected Stations

5.4.5.1

Confirming All Recognized Addresses

When the procedures described on section "5.4 S−LINK I/O Device Address
Recognition", are completed, the user can confirm the addresses of the S−LINK I/O
devices that have been recognized.
This is useful in preventing problems such as erroneous settings where the same
address may have been assigned to two or more S−LINK I/O devices.
Note
If the same address is assigned to multiple devices, the S−LINK
I/O devices will be recognized as a single device.
Procedure:
1.
2.
5 − 10
Set the RUN/CHK. selector switch to the "CHK."
position.
The S−LINK unit switches to check (CHK.) mode.
The number of recognized connected devices blinks.
(At this time, even if booster is connected, it is not included in the
number of connected devices.)
Press the system SET button.
The smallest of the recognized addresses is displayed.
After this, each time the system SET button is pressed, the recognized
addresses are displayed successively in the ascending order. (only
the first set address in case of multi−channel S−LINK I/O devices)
After the last recognized address is displayed, the number of
recognized connected devices is displayed once again, and then, the
display of the addresses is repeated.
Further, by pressing the system SET button continuously for some
time, the recognized addresses can be displayed successively.
RUN/CHK. selec-
tor switch
FP2 S−LINK Unit