Timing - Panasonic S-Link FP2 Manual

Operation
5.3

Timing

5.3 Timing
After the power supply for the FP2 system is turned on, with the external power supply
for the S−LINK (the power supply between D − G line) already on, it takes approximately
1.8 seconds for the S−LINK input/output data to be refreshed.
A timer or similar device should be used to boot the program, so that the program boots
after the data has been refreshed.
Power supply turned on
S−LINK
input/output
Approx. 1.8
data
seconds
refreshed
Note
Make sure an adequate time period is taken into consideration,
allowing time after booting the system for S−LINK input to pass
through the b contact, and other operations to be completed.
5 − 6
FP2 S−LINK Unit