Toro Z Master Professional 5000 Series Operator's Manual page 64

1. Whizlock nut
2. Adjuster screw
10. To adjust the single-point system, loosen the
2 bolts at the bottom of the height-of-cut plate
(Figure 94).
Note:
The mower deck is attached in the
back holes at the factory. Refer to
93. If needed, use the front holes for further
adjustment when leveling the mower deck.
1. Mower deck
2. Front hole
Figure 92
3. Jam nut
4. Yoke
Figure
Figure 93
3. Back hole
1. Bolts at the bottom of the height-of-cut plate
g027410
11. If the deck is too low, tighten the single-point
adjustment bolt by rotating it clockwise. If
the deck is too high, loosen the single-point
adjustment bolt by rotating it counterclockwise
(Figure 95).
Note:
Loosen or tighten the single-point
adjustment bolt enough to move the
height-of-cut plate mounting bolts at least 1/3
the length of the available travel in their slots.
This regains some up and down adjustment on
each of the 4 deck links.
1. Single-point-adjustment bolt
g025558
12. Tighten the 2 bolts at the bottom of the
height-of-cut plate
Note:
For most conditions, adjust the black
blade tip 6.4 mm (1/4 inch) higher than the front.
13. Torque the 2 bolts to 37 to 45 N∙m (27 to 33 ft-lb).
64
Figure 94
Figure 95
(Figure 94).
g027345
g009042