Stopping The Machine; Adjusting The Height Of Cut - Toro Z Master Professional 5000 Series Operator's Manual

Figure 22
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, look behind and slowly pull the
motion-control levers rearward
Figure 23

Stopping the Machine

To stop the machine, move the traction control levers
to N
disengage the blade-control switch (PTO), and turn
the ignition key to the O
Set the parking brake when you leave the machine;
refer to
the key from the ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.

Adjusting the Height of Cut

g008952
Using the Transport Lock
The transport lock has 2 positions and is used with
the deck-lift pedal. There is a L
an U
mower deck
(Figure 23).
g008953
25
and then to the N
EUTRAL
FF
Setting the Parking Brake (page
CAUTION
position for the transport position of the
NLOCK
(Figure 24).
- position,
EUTRAL LOCK
position.
20). Remove
position and
OCK