Toro Z Master Professional 5000 Series Operator's Manual page 39

Changing the Engine Oil
Service Interval: Every 100 hours (more often in dirty
or dusty conditions).
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the rear is slightly lower
than the front to ensure the oil drains completely.
2. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position
Figure 46
-
EUTRAL
(Figure 46).
4. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the F
47).
LOCK
g024213
5. Start the engine and drive to a flat area.
6. Check the oil level again.
Changing the Engine-Oil Filter
Service Interval: Every 200 hours
Note:
Change the engine-oil filter more frequently
when operating conditions are extremely dusty or
sandy.
1. Drain the oil from the engine; refer to
the Engine Oil (page
2. Change the engine-oil filter
g027734
39
mark
ULL
Figure 47
Changing
39).
(Figure 48).
(Figure
g027660