Adjusting The Anti-Scalp Rollers - Toro Z Master Professional 5000 Series Operator's Manual

Figure 24
Transport-Lock Positions
1. Transport lock
2. L position—The
OCK
mower deck locks into the
transport position.
Adjusting the Height-of-Cut Pin
The height of cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1. Move the transport lock to the lock position.
g032377
3. U position—The
NLOCK
mower deck does not lock
into the transport position.
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inch) cutting-height
position) (Figure
3. To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
25).
4. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired and
insert the pin (Figure
5. Push on the deck-lift pedal, pull back on the
transport lock, and slowly lower the mower deck.
1. Deck-lift pedal
2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, it is
recommended to adjust the height of the anti-scalp
rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
26 and Figure
26
25).
25).
Figure 25
3. Transport lock
EUTRAL
27.
(Figure
g027343
-
LOCK
Figure