Ignition Switch; Throttle Control - Toro Z Master Professional 5000 Series Operator's Manual

1. Fuel gauge (bars)
2. Battery light
3. Hour meter

Throttle Control

The throttle control is variable between Fast and
Slow.
Figure 6
4. Safety-interlock symbols
5. Low fuel indicator light
Blade-Control Switch (PTO)
The blade-control switch (PTO) is used to engage
the electric clutch and drive the mower blades. Pull
the switch up to engage the blades and release. To
disengage the blades, push the blade-control switch
(PTO) down or move a motion-control lever into the
N -
EUTRAL LOCK

Ignition Switch

This switch is used to start the mower engine and has
3 positions: S
TART
g008950
Motion-Control Levers
The motion-control levers are used to drive the
machine forward, reverse, and turn either direction.
Neutral-Lock Position
The N -
EUTRAL LOCK
safety-interlock system to engage and to determine
N position.
EUTRAL
Fuel-Shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
Electronic Control Unit
Malfunction Indicator Light
The electronic control unit (ECU) continuously
monitors the operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) is illuminated.
The MIL is the red light located in the right console
panel.
Once the MIL illuminates, perform initial trouble
shooting checks. Refer to the MIL section under
Troubleshooting (page
If these checks do not correct the problem, further
diagnosis and servicing by an Authorized Service
Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
15
position.
, R , and O .
UN FF
position is used with the
71).