Charging The Battery - Toro Z Master Professional 5000 Series Operator's Manual

Charging the Battery

WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
2. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 57).
3. Install the battery in the machine and connect
the battery cables, refer to
(page 44).
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 56
Installing the Battery
1. Positive battery post
g032526
2. Negative battery post
45
Figure 57
3. Red (+) charger lead
4. Black (-) charger lead
g000960