Think Safety First - Toro Z Master Professional 5000 Series Operator's Manual

Figure 8
1. ROPS knob
2. Pull the ROPS knob out
and rotate it 90 degrees.
4. To raise the roll bar, raise the roll bar to the
operate position and rotate the knobs so they
move partially into the grooves
5. Raise the roll bar to the full upright position while
pushing on the upper roll bar and the pins will
snap into position when the holes align with the
pins (Figure 8). Push on the roll bar and ensure
that both pins are engaged.
Important:
Always use the seat belt with the
roll bar in the fully raised position.
g008943
3. Roll bar in the upright
position
4. Roll bar in the folded
position
(Figure 8).

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
DANGER
Operating the machine on wet grass or steep
slopes can cause sliding and loss of control.
• Do not operate on slopes greater than 15
degrees.
• Reduce speed and use extreme caution on
slopes.
• Do not operate the machine near water.
DANGER
Wheels dropping over edges can cause
rollovers, which may result in serious injury,
death, or drowning.
Do not operate the machine near drop-offs.
DANGER
Operating the machine while the roll bar is
down may lead to serious injury or death in
the event of a rollover.
Always keep the roll bar in the fully raised and
locked position and use the seat belt.
19