Drive System
Maintenance
Checking the Seat Belt
Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the
Rollover-Protection System
(ROPS) Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the rear part of the seat is secured
with the seat latch.
Check that both the mounting hardware and the knobs
are in good working condition. Make sure the knobs
are fully engaged with the ROPS in the raised position.
The upper hoop of the roll bar may need to be pushed
forward or pulled rearward to fully engage both knobs.
1. ROPS knob (locked
position)
2. Pull the ROPS knob out
and rotate it 90 degrees to
change roll bar position.
Adjusting the Tracking
1.
Disengage the blade-control switch (PTO).
2.
Drive to an open, flat area and move the
motion-control levers to the N
position.
3.
Move the throttle midway between the F
S
positions.
LOW
4.
Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5.
Check which way the machine tracks.
6.
If it tracks to the right, loosen the bolts and adjust
the left stop plate rearward on the left T-slot until
the machine tracks are straight
48
Figure 62
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-
EUTRAL
LOCK
(Figure
g008943
and
AST
63).