Hydraulic System Maintenance; Servicing The Hydraulic System - Toro Z Master Professional 5000 Series Operator's Manual

3. Tighten jam nut.
Figure 86
1. Flanged nut
g008621
2. Jam nut
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Fluid Type: Toro
hydraulic oil or Mobil
Important:
Use the hydraulic fluid specified.
Other fluids could damage the hydraulic system.
Each Hydraulic System Oil Capacity: 1.5 L (52 oz)
per side with filter change
Checking the Hydraulic Fluid
Service Interval: Every 50 hours—Check the
hydraulic-fluid level.
1. Position the machine on a level surface.
2. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Allow the engine and hydraulic system to cool
for 10 minutes.
Note:
The fluid level on the dipstick is incorrect
if you check the fluid when the machine is hot.
5. Move the seat forward.
6. Clean the area around the dipsticks of hydraulic
system reservoirs
7. Remove 1 dipstick from the hydraulic reservoir
(Figure 87).
8. Wipe the dipstick off and thread the dipstick into
the reservoir.
9. Remove the dipstick and look at the end
87). If the fluid level is at the A
slowly pour only enough fluid into the hydraulic
reservoir to raise the level to the F
Important:
Do not overfill the hydraulic
units with fluid as damage may occur. Do
not run the machine with the fluid below the
add mark.
10. Install the dipstick.
11. Repeat procedure for the opposite dipstick.
60
® HYPR-OIL ™
® 1 15W-50.
EUTRAL
(Figure 87).
mark ,
DD
ULL
500
-
LOCK
(Figure
or H line.