Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so the rollers do
not touch the ground in normal, flat mowing areas.
1.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position and set the parking brake.
2.
Stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown in
20
to match the closest height-of-cut position.
Figure 20
1. Anti-scalp roller
2. Bolt
Positioning the Seat
The seat can move forward and backward. Position
the seat where you have the best control of the
machine and are most comfortable
-
EUTRAL
LOCK
Figure
g010233
3. Flange Nut
4. Hole spacing
(Figure
21).
24
Figure 21
g027632