Table of Contents
Advertisement
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1.
Park the machine on a level surface, disengage
the PTO, and move the motion-control levers
outward to the P
ARK
2.
Shut off the machine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Adjust the anti-scalp rollers as shown.
Figure 36
Left anti-scalp roller
1. Flange nut
2. Spacer
3. Anti-scalp roller
Figure 37
Middle anti-scalp roller
1. Flange nut
2. Anti-scalp roller
position.
4. Bushing
5. Bolt
3. Bushing
4. Bolt
1. Flange nut
2. Spacer
3. Anti-scalp roller
Positioning the Flow Baffle
The following figures are recommendations only.
Adjustments vary by grass type, moisture content,
and the height of the grass.
Remove the knob and carriage bolt, adjust the baffle
g398002
to the appropriate position, and install the knob and
carriage bolt.
Note:
Some machines will use the outer or inner
holes, depending on the size of the mower deck.
Note:
If the power draws down and the mower
ground speed is the same, open the baffle.
g398003
1. Knob and carriage bolt
Position A
This is the fully-rear position. The suggested use for
this position is as follows:
•
Short, light grass mowing conditions
•
Dry conditions
29
Figure 38
Right anti-scalp roller
4. Bushing
5. Bolt
Figure 39
2. Baffle under deck
g398004
g401984
Advertisement
Table of Contents
