12.8.1 Impulse Hose - Stihl MS 201 Manual

1
: Push the cover (1) into the tank
housing as far as stop – the
round and elongated pegs
(arrows) must be properly
seated.
1
2
: Position the impulse hose (1) in
the guides (arrows) and push it
home until the lug (2) is on top of
the hose (1).
The lug (2) must locate against the
knob (3).
Make sure the elbow connector (4)
is pushed fully home.
MS 201, MS 201 C, MS 201 T, MS 201 TC
1
: Push the tabs (2) of the cover (1)
into their seats (arrows) until they
snap into place.
4
2
3
Make sure that the fuel hoses and
the impulse hose are not pinched.
: Push the tabs (2) of the cover (1)
into their seats (arrows) in the
tank housing until they snap into
place.
– Fit the handle housing
MS 201, b 10.4
MS 201 T, b 10.5
– Install the carburetor.
MS 201, b 12.4
MS 201 T, b 12.5
– Reassemble all other parts in the
reverse sequence.

12.8.1 Impulse Hose

A damaged impulse hose can result
2
in engine running problems.
2
– Troubleshooting, b 3.6 or
b 3.7
– Removing the carburetor
MS 201, b 12.4
MS 201 T, b 12.5
– Remove the handle housing,
MS 201, b 10.4
MS 201 T, b 10.5
– Remove the cover, b 12.8
1
2
1
: Pull the impulse hose (1) out of
the guides (arrows).
1
: Pull the impulse hose (1) off the
nipple (arrow).
– Check the impulse hose and
replace if necessary.
109