Stihl MS 201 Manual page 23

1
2
: Pull the brake lever (2) out of the
hand guard (1).
– Pull the hand guard out of the
opening.
: Check the stop (3) and replace if
necessary
– Inspect the brake lever and hand
guard and replace if necessary.
When installing the stop, make sure
it is properly positioned in the
sprocket cover guide and lies flat.
– Check the pivot pin, replace if
necessary, b 5.5
– Inspect the flat spring and
replace if necessary, b 5.4
– Clean all disassembled parts,
b 14
22
Installing
3
1
– Lubricate the pivot pins with
STIHL lubricant, b 14
: Push the hand guard (1) through
the opening (arrow).
1
– Line up the brake lever
– the forked opening (arrow)
must face the brake band.
: Push the brake lever (1) into the
hand guard and line up the holes.
: Lift the bearing boss of the hand
guard and the brake lever a little
and position them over the pivot
pins (arrows).
1
2
: Ease the cam (arrow) of the hand
guard (1) past the flat spring (2).
– Push the hand guard and brake
lever onto the pivot pins, moving
the hand guard to and fro at the
same time.
1
: Fit the E-clip (1).
MS 201, MS 201 C, MS 201 T, MS 201 TC