Stihl MS 201 Manual page 44

1 2
: Lift the ignition module (1) a little
and pull the ignition lead (2) out
of the guide.
1
: Pull the ignition lead (1) from
between the tank housing and
engine.
2 1
: Remove the cable retainer (1)
and connector tag (2).
– Check ignition lead, replace
ignition module if necessary.
– Check the spark plug boot and
replace if necessary, b 7.4
– Troubleshooting, b 3.5
MS 201, MS 201 C, MS 201 T, MS 201 TC
Installing
1
– Coat end of the ignition lead with
STIHL press fluid, b 14
: Push the ignition lead (1) through
the guide (arrow) at the ignition
side.
1
: Push the ignition lead (1) through
the guide (arrow) at the clutch
side.
1
: Pull the ignition lead (1) into the
clutch side until the first mark
(arrow) is visible at the guide.
1
The second mark (arrow) on the
ignition lead (1) must be located at
the start of the guide on the ignition
side.
1
: Push the ignition lead (1) into the
guide (arrow) as far as stop.
2
: Place the connector tag (1) in its
seat (arrow) in the cable
retainer (2) and press it down
until it snaps into position.
1
43