Stihl MS 201 Manual page 50

1
2
: Take out the screw (1) and pull
the wiring harness (2) out of the
guides (arrows).
1
: Press out the grommet (1) in
direction of carburetor box.
: Pull the ground wire (1) out of the
guides (arrows).
MS 201, MS 201 C, MS 201 T, MS 201 TC
1
2
: Press out grommet (1) in
direction of carburetor box and
pull out ground wire (2) in the
same direction.
1
: Pull the short circuit wire (1) and
ground wire (2) out of the guides
(arrows).
: Pull the grommets (3) and (4) off
the wiring harness.
1
: Pull the wiring harness (1) out
through the hole (arrow).
– Check the wiring harness and
replace if necessary.
Installing
: Thread the wiring harness (1),
3
2
4
2
: Push the grommet (1) onto the
: Push the grommet (5) onto the
1
1 2
3
connector sleeves (2) and (3)
first, through the hole (arrow) in
the handle housing.
4 1
short circuit wire (2) and ground
wire (3) until it locates against the
protective tube (4).
ground wire (3).
3
5
49