Stihl MS 201 Manual page 36

1
2
: Push out the connector (1) and
take out the screw (2).
: Take out the screws (arrows).
1
2
: Back off the spindle (1) in the
puller until it is clear of the
crankshaft stub.
Locate the service tool so that the
spindle is centered on the
crankshaft stub.
MS 201, MS 201 C, MS 201 T, MS 201 TC
: Push the service tool
5910 890 2205 on to the collar
screw, screw home the screw (2),
fit the nut (3) and tighten it down
firmly.
: Turn the spindle (1) clockwise
until the crankcase is released.
– Remove the service tool.
– Pull off the clutch side of the
crankcase.
3
: Remove the gasket (1).
1
1
: Pull out the crankshaft (1).
The crankshaft, connecting rod and
needle bearing form an inseparable
unit.
– Inspect the two halves of the
crankcase and replace if
necessary, b 6.5
– Install new bearings, b 6.5.1
– Clean the crankshaft, b 14
Take care not to damage the
crankshaft stubs.
Inspect and clean the sealing faces
on both halves of the
crankcase (including the cylinder
sealing face) – the sealing faces
must not be damaged in any way,
b 14.
1
35