Control Levers; Master Control Lever - Stihl MS 201 Manual

10.

Control Levers

10.1

Master Control Lever

MS 201
The positions of the Master Control
lever are described in the instruction
manual.
MS 201 T
The positions of the Master Control
lever are described in the instruction
manual.
10.1.1 Switch Shaft (MS 201)
– Remove the air filter, b 12.1
– Remove the handle molding,
b 10.2
– Remove the choke and throttle
rods, b 10.3.1
– Remove the lockout lever and
throttle trigger, b 10.2
74
3
2
1
: Pry the switch shaft (1) out of its
mount (2).
: Pull the choke rod (3) out of the
hole (arrow).
1
: Lift the switch shaft (1) a little and
rotate it towards the intake
manifold until the lever (arrow) is
above the handle housing.
: Pull out the switch shaft (1) in
direction of ignition side.
1 2
: Disconnect terminal (1) of short
circuit wire (2).
– Inspect the switch shaft and
replace if necessary.
Installing
3 1 2
: Fit the short circuit wire (1) over
the switch shaft (2).
: Push the connector sleeve (3)
into its seat (arrow) as far as stop.
1
2
: Push the switch shaft (1) into the
pivot mount (arrow) and rotate it
so that the lever (2) is above the
handle housing.
1
: Lift the switch shaft (1) a little and
push it into the pivot mount
(arrow) until it snaps into position.
MS 201, MS 201 C, MS 201 T, MS 201 TC