Handle Housing (Ms 201 T) - Stihl MS 201 Manual

2
: Push bearing plug (1) with lug
into recess (arrow) in crankcase
as far as stop.
: Coat the screw (2) with Loctite, fit
it and tighten it down firmly, b 14
– Install annular buffer on the fuel
tank, b 9.1
– Install the ignition module, b 7.2
– Fit cover on oil pump and push
bumper strip into its seat, b 9.2
– Install the tank vent, b 12.9.2
– Install the carburetor, b 12.4
– Reassemble all other parts in the
reverse sequence.
10.5 Handle Housing
(MS 201 T)
– Remove cover from oil pump and
pry out the bumper strip, b 9.2
– Remove the AV spring, b 9.2.1
– Remove the carburetor, b 12.5
– Remove the tank vent, b 12.9
86
– Remove the choke and throttle
rods with double lever, b 10.3.2
– Remove the lockout lever and
throttle trigger, b 10.3
1
– Remove the switch shaft,
b 10.1.2
– Remove the handlebar, b 9.3.1
3
: Pull contact spring (1) of short
circuit wire (2) and contact
spring (3) of ground wire (4) out
of guides (arrows).
1
: Take out the screw (1).
: Lift the handle housing (1) a little
and push out the manifold (2) in
direction of cylinder.
1
2
1
3
4
: Lift the handle housing (1) a little
and pull the tank vent hose (2)
and fuel suction hose (3) through
the opening (arrow).
: Turn the handle housing (1) over
and pull the impulse tube (2) out
of its seat (arrow) in the handle
housing.
MS 201, MS 201 C, MS 201 T, MS 201 TC
2
1
2
1 2