1
2
: Position the manifold flange (1)
so that the recesses (arrows)
locate against the screw sleeves
and the tab (2) is seated in the
recess.
1
2
: Position the grommet (1) so that
the peg (2) faces the hole
(arrow).
2
– Coat grommet with STIHL press
fluid, b 14
: Push the grommet (1) into the
opening (arrow) until it is properly
seated and the peg (2) is firmly
located in the hole.
MS 201, MS 201 C, MS 201 T, MS 201 TC
: Fit the stop buffer (1).
1
: Push the retainer (1), small
nipple (2) first, through the hole
(arrow).
1
1
: Attach the retainer (1) to the slot
(arrow) and push it in direction of
chain as far as stop.
: Hold the retainer (1) in that
position.
1
1
: Position the clamping block (1)
with the lug (2) facing outwards,
then push it into the seat (arrow)
as far as stop.
2
: Push the bearing plug (1) into its
seat (arrow) on the underside of
the machine.
: Coat the screw (2) with Loctite, fit
it and tighten it down firmly, b 14
2
1
2
85